Subject	2 cylinders down.. anone know what this might be? i replaced
Posted by	gijew302 on April 24, 2008 at 7:46 PM
	This message has been viewed 170 times.
Message	my ignition switch today. as i was trying to fix the old one, i let thee engine get flooded a few times yesterday and the day before. with the new switch the car starts right up, but only runs on 4 cylinders. the 2 that are down are the the one closest to the battery, and the middle cylinder on the driver side. i switched coils and plugs around and everything is good, but those cylinders are not working. i dried the cylinders with an air compressor as well. could this be the ignition module or something with the distribution? for some reason those 2 coils are not getting power...anyone have any help?
Follow Ups	2 cylinders down.. anone know what this might be? i replaced - gijew302 19:46:21 04/24/08 How old is your ecu harness (n/m) - 818TTZ(SoCal) 20:37:19 04/24/08 Did you happen to mess w/ the PTU or CAS while doing - ThunderZ 06:35:41 04/25/08 where are those located? theres a round thing with wires - gijew302 11:05:00 04/25/08 That's the PTU wiring. CAS on the driver side. - ThunderZ 22:08:27 04/25/08 Two bad injectors...should check 10-14 ohms (n/m) - Noncon 21:55:22 04/26/08
Post a Followup	You cannot reply to this message because you are not logged in.