Subject	Rear inner tie rod
Posted by	smerrkz on April 23, 2008 at 11:32 AM
	This message has been viewed 162 times.
Message	hi , just wondering if this is difficult with just jack stands and no hoist. Also is it neccessary to remove the exhaust? Cause mine is not that easy to remove as it was custom built. I checked faq and searched and didnt find too much info. is this an easy job? Do I need that special wrench that is thinner or has anyone found a better way?? Thanks guys, Mark
Follow Ups	Rear inner tie rod - smerrkz 11:32:22 04/23/08
Post a Followup	You cannot reply to this message because you are not logged in.