Subject	As far as I know, it's held open by a small spring
Posted by	en5 on April 21, 2008 at 4:03 PM
	This message has been viewed 244 times.
In Reply To	What reverts the switch back to the "open" state? (n/m) posted by spicyZ on April 21, 2008 at 12:10 PM
Message	At least that's how most switches and relays function. The magnet is stronger than the spring, which pulls the other piece into contact allowing continuity. I'm sure you can find something suitable on eBay for cheap. It's the kind of thing that you can put on your home window or door to alarm when it is opened and the pieces come away from each other.
Follow Ups	Looking for ideas on ignition/kill switch - spicyZ 08:31:15 04/21/08 so you DID consider pulling my dash for a moment there! :) (n/m) - ZEngineer 08:54:38 04/21/08 Yes. - spicyZ 08:56:59 04/21/08 fuel pump relay (n/m) - The Devils Z 09:58:56 04/21/08 READ the post, then respond, thanks. (n/m) - spicyZ 10:35:22 04/21/08 Magnetic Switch... - nosduj 10:45:48 04/21/08 that works, but it doesn't answer the question. Allow me to - ZEngineer 10:55:04 04/21/08 How about a magnetic switch that toggles the starter relay - en5 11:17:20 04/21/08 Similar idea, but a PITA if I understand it correctly - spicyZ 11:42:37 04/21/08 I imagined that it was like a magnetic wand that when - en5 15:58:52 04/21/08 Actually, I think nosduj has the right idea - spicyZ 11:39:09 04/21/08 Re: Actually, I think nosduj has the right idea - nosduj 11:57:08 04/21/08 What reverts the switch back to the "open" state? (n/m) - spicyZ 12:10:24 04/21/08 As far as I know, it's held open by a small spring - en5 16:03:42 04/21/08 I did read your original post - The Devils Z 12:37:11 04/21/08 A contact/pressure switch is only on for as long... - spicyZ 13:04:52 04/21/08 I could be wrong --but you may be able to wire it in - The Devils Z 13:37:59 04/21/08 We have a large range of knowledge here - spicyZ 14:03:22 04/21/08 Perhaps a Timer Relay was used. - ked8923 14:38:31 04/21/08 I believe it would be the Off-Delay relay - ked8923 14:51:22 04/21/08 Hmmmm.. interesting... you could be right here. - spicyZ 14:59:25 04/21/08 np ;) (n/m) - ked8923 15:07:50 04/21/08 and... - ked8923 18:28:21 04/21/08 Try this place - not sure how expensive these are? - jzack 19:44:59 04/21/08 Since you've actually implemented something like this - spicyZ 20:12:22 04/21/08 Here is my solution, complete with part numbers - nosduj 22:49:28 04/21/08 WOW! This is exactly the type of info I'm looking for - spicyZ 07:45:35 04/22/08 good information !!!! nice use of radio shack p/n - The Devils Z 11:16:33 04/22/08 I see no reason why I can't substitute the magnetic - spicyZ 11:36:15 04/22/08 Yep or go really fancy and use some kind of biometric - jzack 18:13:25 04/22/08 bypass - nosduj 20:57:36 04/22/08 Nice write-up. (n/m) - TT XTZ 14:20:03 04/22/08 Well one I installed on an SUV used an aftermarket - jzack 23:00:13 04/21/08 This is also excellent information. - spicyZ 07:47:35 04/22/08 nice -- this system looks like it's a active 100% - The Devils Z 11:22:10 04/22/08 I always install a bypass switch across the contacts - jzack 11:56:57 04/22/08 I have a switch under my seat that kills starter - Mike87T 08:31:57 04/22/08 I want something more sophisticated than a toggle switch - spicyZ 08:48:57 04/22/08 so maybe just a simple push button switch? - Zluster 15:34:57 04/23/08
Post a Followup	You cannot reply to this message because you are not logged in.