Subject	Wouldn't the TPS voltage be off at idle at that was the
Posted by	The Devils Z on April 21, 2008 at 12:38 PM
	This message has been viewed 233 times.
In Reply To	2nd. Sometimes the connector for the switch part of the posted by MixManMash on April 21, 2008 at 12:04 PM
Message	case of the TPS voltage would change if I wiggled the connector or the harness ? That did not happen. =============Sig begins here================ The Devils Z.com The Devils Z Pic 666 rwhp dyno The Demon Z pic (in progress) View Me! Disclaimer : Not Safe For Work !
Follow Ups	high idle - 1800 RPM question - The Devils Z 18:43:12 04/20/08 Try checking the vent tubes attached to the valve covers - Agner.S(CT) 19:27:16 04/20/08 The only thing that strikes me would be a faulty TPS - en5 19:28:56 04/20/08 2nd. Sometimes the connector for the switch part of the - MixManMash 12:04:48 04/21/08 Wouldn't the TPS voltage be off at idle at that was the - The Devils Z 12:38:43 04/21/08 looks like you may be right on ... (n/m) - The Devils Z 14:43:03 04/21/08 Re: high idle - 1800 RPM question - 300twinz (satx) 19:31:49 04/20/08 i had this issue, although it was due to - inf 19:37:48 04/20/08 Is your Air Regulator working?..vacuum leak? (n/m) - Audioquest 19:42:22 04/20/08 Re: Is your Air Regulator working?..vacuum leak? - The Devils Z 19:48:47 04/20/08 yes --the Throttle body linkage is one of the first things - The Devils Z 19:47:48 04/20/08 mine snapped back too - inf 21:02:56 04/20/08 try slowly letting off of the cable to see if it returns - gt300zxtt 22:53:40 04/20/08 using pic from faq - gt300zxtt 22:58:46 04/20/08 question ..if it was the TB linkage wouldn't the RPM - The Devils Z 06:04:11 04/21/08 not sure - gt300zxtt 09:03:51 04/21/08 possible solution ...the TPS in closed mode --which means - The Devils Z 14:17:54 04/21/08 Hey Devil, had the same weird problem too... - escturbo 06:45:11 04/22/08 look here .. - The Devils Z 07:50:24 04/22/08 SOLUTION FOUND ... it turns out idiot me put one of the - The Devils Z 20:34:00 04/22/08
Post a Followup	You cannot reply to this message because you are not logged in.