Subject	sooo i have a bit of a situation
Posted by	zxtuner161 on April 21, 2008 at 2:00 AM
	This message has been viewed 154 times.
Message	2 of my flywheel crank threads are stripped. what are my possible solutions? I planned on just helicoiling them and using loctite so i drilled the threads out, went to rethread and it's not going very well. The crank metal is really really strong and strips the threads on the tap. What should i do? anyone ever have this problem? i'm hoping i don't have to replace the whole crank over 2 stripped threads. any input is appreciated. a random noob once said: "I think its great that I can make a civilized post among you greater life forms only to have my breasts ripped off by savage milk craving z people."
Follow Ups	sooo i have a bit of a situation - zxtuner161 02:00:41 04/21/08 try a machine shop - ZLover4Life 03:38:40 04/21/08
Post a Followup	You cannot reply to this message because you are not logged in.