Subject	LOL, yeah right after I posted that I went back to look
Posted by	Viper498 ( MO ) on April 19, 2008 at 1:08 PM
	This message has been viewed 158 times.
In Reply To	Here this will help alot... posted by Sleeper_TTZ(SeKy) on April 19, 2008 at 12:59 PM
Message	in the service manual. Sure enough, there it was. DUH! Do you know if you have to use a ring compressor to install the pistons in the cylinders? I wanted to get a lot done on this engine this weekend but if you have to have one then I am dead in the water. I don't even know where to get one. Brock '90 300zx N/A coupe Converting to Twin Turbo!
Follow Ups	No how to on Piston rings? - Viper498 ( MO ) 10:05:17 04/19/08 Here's Wiesco's instructions, - RHulme 10:41:43 04/19/08 Does anyone know if you have to use a ring compressor - Viper498 ( MO ) 12:11:37 04/19/08 when checking the gap - gt300zxtt 13:25:47 04/19/08 When i did mine.. CP pistons there was two different - Sleeper_TTZ(SeKy) 12:40:30 04/19/08 Crap.. Well the instructions I had on the ring set were - Viper498 ( MO ) 12:44:06 04/19/08 Here this will help alot... - Sleeper_TTZ(SeKy) 12:59:59 04/19/08 Here is the link to the entire online service manual... - Sleeper_TTZ(SeKy) 13:02:43 04/19/08 LOL, yeah right after I posted that I went back to look - Viper498 ( MO ) 13:08:32 04/19/08 I had to... You can get you at advance or pep boys.. - Sleeper_TTZ(SeKy) 13:16:29 04/19/08 Thank you for the great advice! Is it ok to put oil on the - Viper498 ( MO ) 13:22:39 04/19/08 I used lucas... but make sure you get something in there... - Sleeper_TTZ(SeKy) 13:27:32 04/19/08 I'll kind of be in the same boat, but if I get ring - Viper498 ( MO ) 13:40:06 04/19/08 Yeah I got the bright idea that since the heads - Sleeper_TTZ(SeKy) 13:49:30 04/19/08 LOL, I wonder when Admin is going to move this to Tech? (n/m) - Viper498 ( MO ) 13:44:57 04/19/08 I was wandering that to. I'm surprised thus far. (n/m) - Sleeper_TTZ(SeKy) 13:50:32 04/19/08
Post a Followup	You cannot reply to this message because you are not logged in.