Subject	Det Sensor wiring breakage is a pretty common issue
Posted by	jzack on April 17, 2008 at 10:22 PM
	This message has been viewed 149 times.
In Reply To	engine problem posted by Jaskozx on April 17, 2008 at 08:46 PM
Message	too (due to age and heat). Wiring breaks up on the top of the plenum where the wiring comes up from below and plugs into the main harness connector (behind balance tube, mid section). Pretty easy to visually check and see if that's happened - fairly easy to repair too.
Follow Ups	engine problem - Jaskozx 20:46:31 04/17/08 first confirm it is your injectors - Ahmed 22:12:31 04/17/08 Det Sensor wiring breakage is a pretty common issue - jzack 22:22:56 04/17/08 There is a simple 1 meg. ohm resistor by-pass procedure - Zirvana 15:05:56 04/18/08
Post a Followup	You cannot reply to this message because you are not logged in.