Subject	Aren't the 4 pads raised above the level of the actual
Posted by	Audioquest on April 17, 2008 at 9:12 PM
	This message has been viewed 118 times.
In Reply To	RPS segmented flywheel (searched-not much) posted by coolron300 on April 17, 2008 at 08:51 PM
Message	outer flywheel surface where the clutch pressure plate housing will mate to? Mine was about 3/32" higher (a guess)
Follow Ups	RPS segmented flywheel (searched-not much) - coolron300 20:51:36 04/17/08 Aren't the 4 pads raised above the level of the actual - Audioquest 21:12:05 04/17/08 Maybe you got a NA flywheel? Not sure if RPS puts a step - Spddracer 19:40:01 04/18/08
Post a Followup	You cannot reply to this message because you are not logged in.