Subject	There is a small lip on the inside edge where you can get a
Posted by	doug8867 on April 12, 2008 at 4:34 PM
	This message has been viewed 170 times.
In Reply To	Exhaust cam cover question posted by LITTLEZ(KY) on April 12, 2008 at 04:29 PM
Message	flat head screwdriver under it. Once you find it place a small two by four parellel with it so you can use it for leverage and you should be able to pry it off then. The RTV sealant is what is holding it tight so you have to break that seal.
Follow Ups	Exhaust cam cover question - LITTLEZ(KY) 16:29:32 04/12/08 There is a small lip on the inside edge where you can get a - doug8867 16:34:19 04/12/08 A 15 inch 1 x 2 works good too - put one end up - jzack 20:28:39 04/12/08 Re: Exhaust cam cover question - txq45 21:38:52 04/12/08
Post a Followup	You cannot reply to this message because you are not logged in.