Subject	Starter Heat Shield / 3" Downpipe Install Question
Posted by	MAD_96TT(MO) on April 11, 2008 at 2:08 PM
	This message has been viewed 522 times.
Message	Doing my own clutch install for the first time, and I just finished putting the transmission back in place. I decided to put the passenger side downpipe on beforehand though. Little did I think about it but, the starter was quite a squeeze to install with the downpipe there. So, I decided to just put it back on without the heat shield. I have a couple questions....will it be ok installed without the shield OR should I find some heat shield wrap? If I wrap it, should I wrap the downpipe with heat shield in that area or should I wrap the starter? Last resort option is unbolting the downpipe again. I don't even think it would fit with the 3" downpipe there....it would scrape it. I am kinda thinking I should wrap the starter so it will also keep water and debris off of it. What do you guys think? Thanks for your help! Z's Kick Ass!! Boost - It's An Addiction! "Like a retired James Bond, the Z exudes an air of understated class." ------> Sports Compact Car Magazine
Follow Ups	Starter Heat Shield / 3" Downpipe Install Question - MAD_96TT(MO) 14:08:32 04/11/08 If you wrap teh starter, any water etc., will stay in there - Audioquest 16:10:48 04/11/08 That is a good point, but would it lead to premature failure - MAD_96TT(MO) 16:40:42 04/11/08
Post a Followup	You cannot reply to this message because you are not logged in.