Subject	Most have had success with de-pinning the white connector...
Posted by	mlov(NJ) on April 09, 2008 at 9:47 AM
	This message has been viewed 173 times.
In Reply To	whos the one who swapped his efi har. w/o engine pull? posted by preprodigy on April 08, 2008 at 05:20 PM
Message	only to get it thru the firewall. Haven't heard of anyone removing the dash. Good luck and report back your experience. I'm next in line b/c I'm replacing my injectors and pulling the plenum. So now is the time I am going to replace my harness as well. Here's a post from 300zxclub.com, hope it helps. [ http://www.300zxclub.com/showthread.php?t=104069&highlight=efi+harness+install ]
Follow Ups	whos the one who swapped his efi har. w/o engine pull? - preprodigy 17:20:15 04/08/08 "the one" ? many have done it. - ali300zx 19:36:16 04/08/08 i did. it was poor experience. i had cut and solder a plug (n/m) - z_samurai 21:02:52 04/08/08 Re: whos the one who swapped his efi har. w/o engine pull? - sandmanz32 22:19:57 04/08/08 Depinning Method - ZDUCTIV 23:49:32 04/08/08 Re: whos the one who swapped his efi har. w/o engine pull? - WazTTed 06:35:57 04/09/08 Most have had success with de-pinning the white connector... - mlov(NJ) 09:47:34 04/09/08
Post a Followup	You cannot reply to this message because you are not logged in.