Subject	I also checked the TPS ohms and volts.
Posted by	inf on April 07, 2008 at 2:02 AM
	This message has been viewed 205 times.
In Reply To	misfiring and rpm takes a while to come down posted by inf on April 07, 2008 at 01:59 AM
Message	The IACV was taken apart and ohmed, and while I couldn't get an ohm reading on the IAA, i 12v it and it clicked.
Follow Ups	misfiring and rpm takes a while to come down - inf 01:59:30 04/07/08 I also checked the TPS ohms and volts. - inf 02:02:17 04/07/08 Also visually checked the CAS and PTU connections (n/m) - inf 02:45:13 04/07/08 Did you run the diag on the o2 sensors? Have you - Audioquest 07:59:15 04/07/08 ya, did all those things. (n/m) - inf 11:53:25 04/07/08 Then it's hard to say. Usually a misfire is caused by - Audioquest 12:01:07 04/07/08 Hmm, I left the boost solenoids disconnected - inf 15:12:03 04/07/08 when mine did that...it was a bad CAS. (n/m) - spotz 12:14:02 04/07/08 what was wrong with it? - inf 17:02:54 04/07/08 Mine spun, it was just screwed inside. - spotz 00:03:25 04/08/08
Post a Followup	You cannot reply to this message because you are not logged in.