Subject	was the crank machined?
Posted by	aliaZ on April 05, 2008 at 8:28 PM
	This message has been viewed 95 times.
In Reply To	Bearing clearences posted by Norz on April 05, 2008 at 12:01 PM
Message	those clearances are too big for a performance rebuild imho My rod clearances on the last two engines that I built were between .0012" to .0014", the mains were about the same if I recall correctly
Follow Ups	Bearing clearences - Norz 12:01:24 04/05/08 Re: Bearing clearences - icsamerica 19:04:26 04/05/08 was the crank machined? - aliaZ 20:28:55 04/05/08
Post a Followup	You cannot reply to this message because you are not logged in.