Subject	Injector Install in NA
Posted by	Thomas+10 on April 05, 2008 at 5:19 PM
	This message has been viewed 173 times.
Message	This morning used the dremmel/grind the aluminum method to remove and replace #4 fuel injector on my 93 NA. Had difficluty getting phillips screws loose until tapped with hammer lightly and soaked with silicone lubricant. Using ratchet extesnion allowing down pressure with phillips they broke free. Was unaware of two holes in top of injector for pulling it out but it was bad anyway. To reinstall new/used injector used small ratched extesnion with socket matching circle on top of injector, also petroleum jelly on o rings. Light tapping placed it firmly in. Used small grinders from NAPA on a drill for the grinding. Job went faster than expected. This site had all the information THANKS. Tom S. S+10
Follow Ups	Injector Install in NA - Thomas+10 17:19:48 04/05/08 Awesome! Thomas + 10 is right! (n/m) - ni[X]it 09:45:03 04/06/08
Post a Followup	You cannot reply to this message because you are not logged in.