Subject	Bearing clearences
Posted by	Norz on April 05, 2008 at 12:01 PM
	This message has been viewed 141 times.
Message	Hi! Didnt find what i was looking for when searching so here goes nothing. I am doing a engine rebuild and have just started the engine assembly. My machineshop ordered all off my engine bearings. The clearences i get at the rod bearings at 40 lbs ft is 0,060mm. I know the limit is 0,090mm so does this mean its fine? Also my main bearings at 70 lbs ft is 0,102 and the limit is also 0,090. Should i change the bearings? Thanks
Follow Ups	Bearing clearences - Norz 12:01:24 04/05/08 Re: Bearing clearences - icsamerica 19:04:26 04/05/08 was the crank machined? - aliaZ 20:28:55 04/05/08
Post a Followup	You cannot reply to this message because you are not logged in.