Subject	10mm Gear Wrench flex head ratcheting wrench FTW! (n/m)
Posted by	doug8867 on April 04, 2008 at 6:56 PM
	This message has been viewed 125 times.
In Reply To	plenum removal question... posted by Madhatter10-6 on April 04, 2008 at 06:00 PM
Message
Follow Ups	plenum removal question... - Madhatter10-6 18:00:50 04/04/08 The first time I did it many years ago, I used a cut-off - whitepearlz 18:04:51 04/04/08 that would work fine - aliaZ 18:05:22 04/04/08 I just used a universal joint and a 10mm socket. (n/m) - rojoloco (San Diego) 18:07:25 04/04/08 Are you going to keep that on there. I just cut the - Sleeper_TTZ(SeKy) 18:14:31 04/04/08 im going to delete that system - Madhatter10-6 18:16:10 04/04/08 empty holes in the bottom of the plenum that is (n/m) - Madhatter10-6 18:16:56 04/04/08 You can use the flanges from the stock tubes - Kong ZTT GT28RS MD 18:18:42 04/04/08 300 degree makes a kit for them, But I'm taping them - Sleeper_TTZ(SeKy) 18:23:03 04/04/08 The kit... - Sleeper_TTZ(SeKy) 18:24:29 04/04/08 Stubby 10mm ratchet wrench.. - Kong ZTT GT28RS MD 18:17:16 04/04/08 tt.net ROCKS! - Madhatter10-6 18:27:41 04/04/08 Along with those suggestions these should also do the trick - Barry (NJ) 18:31:14 04/04/08 thats what I use... - spyhunterTT + 93Vert(nj) 18:23:33 04/07/08 10mm Gear Wrench flex head ratcheting wrench FTW! (n/m) - doug8867 18:56:57 04/04/08
Post a Followup	You cannot reply to this message because you are not logged in.