Subject	I used pliers and pulled straight up!! Call me crazy or
Posted by	nonstopna on April 01, 2008 at 3:55 PM
	This message has been viewed 109 times.
In Reply To	pulling injector but wont come out posted by splackman88 on March 31, 2008 at 02:33 PM
Message	whatever but I actually had to literally get on top the Plenum then pull straigh up to get it out. It was stuck on there pretty good.forget the PB blaster. Try not to squeeze the top of the injector too hard or it will break the top of it off. Good Luck
Follow Ups	pulling injector but wont come out - splackman88 14:33:54 03/31/08 Re: pulling injector but wont come out - txq45 15:35:39 03/31/08 Grab it with pliers - twist and pull - spicyZ 16:21:13 03/31/08 gently with rag on FI plug, use a needle nose to - mossyoak 16:21:55 03/31/08 While spraying PB Blaster - pull up on the injector a little - jzack 19:02:59 03/31/08 Eat more spinach - 300ZMang 22:25:23 03/31/08 completely trashed plastic top portion when i had tried - jpbzx 01:44:20 04/01/08 Sometimes they don't - bliZard 07:58:45 04/01/08 On one that was really tough for me, I used a long nose - Audioquest 10:04:23 04/01/08 I used pliers and pulled straight up!! Call me crazy or - nonstopna 15:55:03 04/01/08 plenum pull really isn't hard if it came down to it.. - Mike87T 20:52:54 04/01/08 What about replacing the gaskets when you pull off the - nonstopna 01:16:05 04/02/08 For just 1 inj, I wouldn't pull the plenum either. It is - ThunderZ 13:48:18 04/02/08 upper plenum gasket is cheap. - AntiHero 14:49:49 04/02/08
Post a Followup	You cannot reply to this message because you are not logged in.