Subject	Re: pulling injector but wont come out
Posted by	txq45 on March 31, 2008 at 3:35 PM
	This message has been viewed 152 times.
In Reply To	pulling injector but wont come out posted by splackman88 on March 31, 2008 at 02:33 PM
Message	Spraying PB then waiting if it won't come out then.. Keeping spraying and waiting then try again.. Pulling straight up then a twist to the left then right spraying again then trying again...remember to replace injector insulator cover screws with allen head screws.
Follow Ups	pulling injector but wont come out - splackman88 14:33:54 03/31/08 Re: pulling injector but wont come out - txq45 15:35:39 03/31/08 Grab it with pliers - twist and pull - spicyZ 16:21:13 03/31/08 gently with rag on FI plug, use a needle nose to - mossyoak 16:21:55 03/31/08 While spraying PB Blaster - pull up on the injector a little - jzack 19:02:59 03/31/08 Eat more spinach - 300ZMang 22:25:23 03/31/08 completely trashed plastic top portion when i had tried - jpbzx 01:44:20 04/01/08 Sometimes they don't - bliZard 07:58:45 04/01/08 On one that was really tough for me, I used a long nose - Audioquest 10:04:23 04/01/08 I used pliers and pulled straight up!! Call me crazy or - nonstopna 15:55:03 04/01/08 plenum pull really isn't hard if it came down to it.. - Mike87T 20:52:54 04/01/08 What about replacing the gaskets when you pull off the - nonstopna 01:16:05 04/02/08 For just 1 inj, I wouldn't pull the plenum either. It is - ThunderZ 13:48:18 04/02/08 upper plenum gasket is cheap. - AntiHero 14:49:49 04/02/08
Post a Followup	You cannot reply to this message because you are not logged in.