Subject	Look at your A/F Ratio.
Posted by	Red Z on January 29, 2008 at 7:48 PM
	This message has been viewed 173 times.
In Reply To	Datascan screenshots from various Z's posted by Ahmed on January 29, 2008 at 10:22 AM
Message	Looks like it is a little too low. I think it should be at least 100. What are you using for programming? You might have to fine tune the injector size.
Follow Ups	Datascan screenshots from various Z's - Ahmed 10:22:37 01/29/08 I display both O2s, but WHEN you take the screenshot is - Yoshi 12:12:13 01/29/08 i didnt know that about the o2's...i'll have to check - Ahmed 13:21:44 01/29/08 Thanks, looking forward to see your results. (n/m) - Yoshi 16:44:24 01/29/08 mines keep fluctuating - Ahmed 22:16:56 01/29/08 Even after a couple of minutes? That's different than mine. - Yoshi 16:58:44 01/30/08 Look at your A/F Ratio. - Red Z 19:48:43 01/29/08 i have a JWT ecu, dont have a tuning tool (n/m) - Ahmed 12:08:21 01/30/08
Post a Followup	You cannot reply to this message because you are not logged in.