Subject	Re: I don't see why an O2 sensor (NB or WB) being downstream
Posted by	Dallas DamonZ on December 06, 2007 at 5:02 PM
	This message has been viewed 153 times.
In Reply To	I don't see why an O2 sensor (NB or WB) being downstream posted by Dark Diver on December 06, 2007 at 03:56 PM
Message	gas has to flow from the engine to the sensor, that takes some amount of time. The ratio should be correct, but the time it's recorded is more delayed from when it happened. Later "If A equals success, then the formula is: A = X + Y + Z, X is work. Y is play. Z is keep your mouth shut." - Albert Einstein When was the last time you *really* did something with your Z to call yourself a Z enthusiast? Member #1 PETZ
Follow Ups	So I got a Innovate Wideband....now what? - pionkej 10:40:30 12/05/07 i dont remember exactly but i think Ash doesnt recommend - mogaffar 10:47:53 12/05/07 I believe he had ground issues. (n/m) - Dark Diver 15:35:03 12/06/07 Re: So I got a Innovate Wideband....now what? - Dallas DamonZ 10:52:03 12/05/07 That's not a good idea, unless you have a good bit of spare - yobobrox 11:35:27 12/05/07 Re: That's not a good idea, unless you have a good bit of spare - Dallas DamonZ 11:45:41 12/05/07 Ah, ok, yeah now I agree with ya :) - yobobrox 11:59:09 12/05/07 understandable, looking again my wording was confusing. - Dallas DamonZ 12:07:13 12/05/07 I don't see why an O2 sensor (NB or WB) being downstream - Dark Diver 15:56:13 12/06/07 Re: I don't see why an O2 sensor (NB or WB) being downstream - Dallas DamonZ 17:02:35 12/06/07 Re: Re: I don't see why an O2 sensor (NB or WB) being downstream - Dallas DamonZ 17:06:04 12/06/07 Hum, can you estimate the time needed for hot gas - Dark Diver 03:29:55 12/07/07 Thanks for the help....any ideas on the SAFC? - pionkej 13:02:12 12/05/07 I had the same question about installing it in the downpipe - ZEngineer 10:52:05 12/05/07 This shouldn't be a problem because.... - pionkej 13:11:02 12/05/07 That's fine if the RPM is increasing at a fixed rate through - MixManMash 16:21:41 12/05/07 I understand that....but read this. - pionkej 16:28:08 12/05/07 Ok. Good luck. (n/m) - MixManMash 16:35:08 12/05/07 Leave the stock 02's in place. Put it in the test - AZHeat 14:24:45 12/05/07 How do I correlate a tape any better than a time measurement - pionkej 15:16:11 12/05/07 When you record on video you have a timer as - AZHeat 15:45:28 12/05/07 i would recommend NIStune over the SAFC - apudapus 17:06:38 12/05/07 he'll need the SAFC for his dual MAF setup (n/m) - aliaZ 22:55:49 12/06/07
Post a Followup	You cannot reply to this message because you are not logged in.