TwinTurbo.NET: Nissan 300ZX forum - That's fine if the RPM is increasing at a fixed rate through
Subject
That's fine if the RPM is increasing at a fixed rate through
Posted by
MixManMash
on December 05, 2007 at 4:21 PM
This message has been viewed
137
times.
In Reply To
This shouldn't be a problem because....
posted by pionkej
on December 05, 2007 at 01:11 PM
Message
out the sample. I don't think RPM increases at a fixed rate though. Might want to consider adding RPM as an input and measuring A/F vs. RPM.
Follow Ups
So I got a Innovate Wideband....now what?
-
pionkej
10:40:30 12/05/07
i dont remember exactly but i think Ash doesnt recommend
-
mogaffar
10:47:53 12/05/07
I believe he had ground issues. (n/m)
-
Dark Diver
15:35:03 12/06/07
Re: So I got a Innovate Wideband....now what?
-
Dallas DamonZ
10:52:03 12/05/07
That's not a good idea, unless you have a good bit of spare
-
yobobrox
11:35:27 12/05/07
Re: That's not a good idea, unless you have a good bit of spare
-
Dallas DamonZ
11:45:41 12/05/07
Ah, ok, yeah now I agree with ya :)
-
yobobrox
11:59:09 12/05/07
understandable, looking again my wording was confusing.
-
Dallas DamonZ
12:07:13 12/05/07
I don't see why an O2 sensor (NB or WB) being downstream
-
Dark Diver
15:56:13 12/06/07
Re: I don't see why an O2 sensor (NB or WB) being downstream
-
Dallas DamonZ
17:02:35 12/06/07
Re: Re: I don't see why an O2 sensor (NB or WB) being downstream
-
Dallas DamonZ
17:06:04 12/06/07
Hum, can you estimate the time needed for hot gas
-
Dark Diver
03:29:55 12/07/07
Thanks for the help....any ideas on the SAFC?
-
pionkej
13:02:12 12/05/07
I had the same question about installing it in the downpipe
-
ZEngineer
10:52:05 12/05/07
This shouldn't be a problem because....
-
pionkej
13:11:02 12/05/07
That's fine if the RPM is increasing at a fixed rate through -
MixManMash
16:21:41 12/05/07
I understand that....but read this.
-
pionkej
16:28:08 12/05/07
Ok. Good luck. (n/m)
-
MixManMash
16:35:08 12/05/07
Leave the stock 02's in place. Put it in the test
-
AZHeat
14:24:45 12/05/07
How do I correlate a tape any better than a time measurement
-
pionkej
15:16:11 12/05/07
When you record on video you have a timer as
-
AZHeat
15:45:28 12/05/07
i would recommend NIStune over the SAFC
-
apudapus
17:06:38 12/05/07
he'll need the SAFC for his dual MAF setup (n/m)
-
aliaZ
22:55:49 12/06/07
Post a
Followup
You cannot reply to this message because you are not
logged in
.