Subject	Re: That's not a good idea, unless you have a good bit of spare
Posted by	Dallas DamonZ on December 05, 2007 at 11:45 AM
	This message has been viewed 179 times.
In Reply To	That's not a good idea, unless you have a good bit of spare posted by yobobrox on December 05, 2007 at 11:35 AM
Message	I should have been more specific. He's asking about tuning with it. Put it together how I mentioned and when you're done tuning you can easily put the OEM O2 back in place w/o a lot of headache. Then it's easy to swap back and forth as needed. I leave mine in and have 600+ miles of hard track time on it now w/ no failure or issues, but I don't expect it to last forever either. Later "If A equals success, then the formula is: A = X + Y + Z, X is work. Y is play. Z is keep your mouth shut." - Albert Einstein When was the last time you *really* did something with your Z to call yourself a Z enthusiast? Member #1 PETZ
Follow Ups	So I got a Innovate Wideband....now what? - pionkej 10:40:30 12/05/07 i dont remember exactly but i think Ash doesnt recommend - mogaffar 10:47:53 12/05/07 I believe he had ground issues. (n/m) - Dark Diver 15:35:03 12/06/07 Re: So I got a Innovate Wideband....now what? - Dallas DamonZ 10:52:03 12/05/07 That's not a good idea, unless you have a good bit of spare - yobobrox 11:35:27 12/05/07 Re: That's not a good idea, unless you have a good bit of spare - Dallas DamonZ 11:45:41 12/05/07 Ah, ok, yeah now I agree with ya :) - yobobrox 11:59:09 12/05/07 understandable, looking again my wording was confusing. - Dallas DamonZ 12:07:13 12/05/07 I don't see why an O2 sensor (NB or WB) being downstream - Dark Diver 15:56:13 12/06/07 Re: I don't see why an O2 sensor (NB or WB) being downstream - Dallas DamonZ 17:02:35 12/06/07 Re: Re: I don't see why an O2 sensor (NB or WB) being downstream - Dallas DamonZ 17:06:04 12/06/07 Hum, can you estimate the time needed for hot gas - Dark Diver 03:29:55 12/07/07 Thanks for the help....any ideas on the SAFC? - pionkej 13:02:12 12/05/07 I had the same question about installing it in the downpipe - ZEngineer 10:52:05 12/05/07 This shouldn't be a problem because.... - pionkej 13:11:02 12/05/07 That's fine if the RPM is increasing at a fixed rate through - MixManMash 16:21:41 12/05/07 I understand that....but read this. - pionkej 16:28:08 12/05/07 Ok. Good luck. (n/m) - MixManMash 16:35:08 12/05/07 Leave the stock 02's in place. Put it in the test - AZHeat 14:24:45 12/05/07 How do I correlate a tape any better than a time measurement - pionkej 15:16:11 12/05/07 When you record on video you have a timer as - AZHeat 15:45:28 12/05/07 i would recommend NIStune over the SAFC - apudapus 17:06:38 12/05/07 he'll need the SAFC for his dual MAF setup (n/m) - aliaZ 22:55:49 12/06/07
Post a Followup	You cannot reply to this message because you are not logged in.