Subject	Thread size/pitch for stock Oil Pressure Sending Unit?
Posted by	amorak on September 01, 2006 at 1:32 AM
	This message has been viewed 1441 times.
Message	Since the JDM oil pressure sending unit is pretty much unreachable, I am going to do the next best thing: Install an aftermarket gauge! Because the JDM sending unit is on the other side of the block, apparently the stock North American location is avaialbe, with just a bolt blocknig it off. So I am thinking I will tee into there - What's the size/pitch of that hole? Thanks!
Follow Ups	Thread size/pitch for stock Oil Pressure Sending Unit? - amorak 01:32:51 09/01/06 1/8 bspt - Tuppidsay 14:37:37 09/01/06 Re: Thread size/pitch for stock Oil Pressure Sending Unit? - aace73 19:17:31 09/01/06 what? its easy to get too.. I just swapped the plug/sender - musky 22:05:18 09/01/06
Post a Followup	You cannot reply to this message because you are not logged in.