TwinTurbo.NET: Nissan 300ZX forum - IMHO no need to get the 5 speed wiring harness
People Seeking Info
 
   


     
Subject IMHO no need to get the 5 speed wiring harness
     
Posted by MidLifeZ (DFW) on August 21, 2006 at 4:44 PM
  This message has been viewed 428 times.
     
In Reply To If the 5 speed wiring harness is available, is that a easier posted by ZonaZ on August 21, 2006 at 01:03 PM
     
Message It does not get used at all except for one connector end and the wires connected to it.

The one I got was used and cracked so not of use except for the wire itself.

Get connectors for the backup light and neutral switch connectors on the transmission from YugoBernie. Then solder in some wire to them. Connect to the sensors and run the wires. One runs, see my write up, to the engine bay, right side for the back up lights. Still trying to figure out where to splice in the neutral switch so for now mine is not connected to anything.

_________________________________________________________________________________________


_________________________________________________________________________________________
Got a Treo 650? Click here for a Z skin for your Treo 650!

Background on my Z

Check out my parts for sale and parts I need!

Need work done on your Z in the DFW Texas area at reasonable prices? Brakes, suspension, timing belt, clutch, etc.? Shoot me an email...

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.