Subject	Bingo! You're absolutely right :)
Posted by	SpdDemon13 (Baltimore) on December 20, 2000 at 11:32 PM
	This message has been viewed 13 times.
In Reply To	OK.... here goes..... posted by Grec (East Bay, CA) on December 20, 2000 at 04:02 PM
Message	Deep dish is usually negative off set (unless there's a widebody conversion but that's also debatable). And yes, off sett is measured in millimeters (mm). Harry 1992 Z Twin Turbo - Stage 4+ 1993 Honda Prelude VTEC ICQ # 1553422 Check my site out! "OMG! I'm going straight to HELL!!!!" - Wolf [Pittsburgh] Click to find out why... LOL
Follow Ups	OK....I'm wheel/tire retarded >>>> - wesman [92TT-less in big D] 15:52:45 12/20/00 Dear Retard! LOL The off set is required in order - LRD VDR 16:01:02 12/20/00 The more offset, the more bearing wear/stressing. (n/m) - nixit [phukslut] 16:08:39 12/20/00 Hence broken axles on those lame-ass lowriders... :-) (n/m) - Grec (East Bay, CA) 16:11:50 12/20/00 Wouldn't - offset stress bearings much more than +? (n/m) - MikeeZ 16:34:12 12/20/00 Re: Correct!!! (n/m) - Roscoe BSP317 18:16:45 12/20/00 say ? (n/m) - nixit [phukslut] 18:18:52 12/20/00 I said ... - MikeeZ 09:48:34 12/21/00 That's what I was fiziguring >>> - wesman [92TT-less in big D] 17:00:03 12/20/00 OK.... here goes..... - Grec (East Bay, CA) 16:02:03 12/20/00 Bingo! You're absolutely right :) - SpdDemon13 (Baltimore) 23:32:29 12/20/00 Here's a picture for you about offset>> - Bernie 16:04:16 12/20/00 So... is that pic positive or nagative? Positive right? (n/m) - Grec (East Bay, CA) 16:07:15 12/20/00 yup, positive. (n/m) - Bernie 16:07:50 12/20/00 Woohoo! I know my shit! Yeehaww! lol... : P (n/m) - Grec (East Bay, CA) 16:10:07 12/20/00 That's beautiful Bro, Wes did ya see this? (n/m) - LRD VDR 16:10:20 12/20/00 Re: Can we FAQ a picture? worth a thousand...you know rest. (n/m) - Roscoe BSP317 18:18:57 12/20/00 He Wes, you have three Zs? Alright! Are they all auto?>> - Zster 18:53:19 12/20/00
Post a Followup	You cannot reply to this message because you are not logged in.