Subject	Here ya go.
Posted by	nissanzxman on September 12, 2003 at 7:20 AM
	This message has been viewed 51 times.
In Reply To	Re: Nissanzxman & I just picked up his motor from the machinist posted by SactoTodd on September 11, 2003 at 02:51 PM
Message	Weisco pistons .020 over (bored obviously) Eagle H beam rods molybdenum coated graphite bearings Larger Manley SS Exhaust valves 5 angle valve job Heads ported and polished Crank had to be cut Full gasket kit Engine cleaning heads remounted before i picked it up Its was the same guy that works with SilvertwinOH. I bought my Z with 15 compression in #6. As boileralum said, it was missing a rather large chunk of piston. The total for that work was $3380. The other 500 was a huge parts list from Coz (props to coz) including tensioners, belts, and all the 60k and new parts for putting a new motor back in the car.
Follow Ups	What is the AVg. cost to rebuilt motor? - Stickeefingerz 13:44:54 09/11/03 $4,937.48 - therinL 13:52:37 09/11/03 Nissanzxman & I just picked up his motor from the machinist - boileralum 14:02:28 09/11/03 what is the etc.. sounds like robbery - big gixx 14:46:04 09/11/03 forgot he also got larger Manley SS exhaust valves - boileralum 15:09:03 09/11/03 What is the difference between stock oil pump and toga? (n/m) - MikeH(Twin GT35BB Incon Z) 17:56:50 09/11/03 Re: Nissanzxman & I just picked up his motor from the machinist - SactoTodd 14:51:04 09/11/03 it had to be bored slightly for the larger pistons. His - boileralum 15:12:43 09/11/03 thanks. (n/m) - SactoTodd 16:19:26 09/11/03 Here ya go. - nissanzxman 07:20:29 09/12/03
Post a Followup	You cannot reply to this message because you are not logged in.