Subject	it had to be bored slightly for the larger pistons. His
Posted by	boileralum on September 11, 2003 at 3:12 PM
	This message has been viewed 42 times.
In Reply To	Re: Nissanzxman & I just picked up his motor from the machinist posted by SactoTodd on September 11, 2003 at 02:51 PM
Message	#6 piston was missing a chunk of the ring lands about 1/4 the way around the piston (and the rod bearing was very close to spinning), so the block was scored pretty bad. I'm not sure what type of balancing was done to the assembly. Rule #1 - There's always a bastard! JRH(KY): for some reason, when I hear the word 'tranny' I think of transvestite before I do transmission. don't ask me why boileralum: FAGMO! ----------------------------------------- Bill (ImTheDevil): blah blah blah me: Just because you are covered in gasoline right now, doesn't mean you are right!
Follow Ups	What is the AVg. cost to rebuilt motor? - Stickeefingerz 13:44:54 09/11/03 $4,937.48 - therinL 13:52:37 09/11/03 Nissanzxman & I just picked up his motor from the machinist - boileralum 14:02:28 09/11/03 what is the etc.. sounds like robbery - big gixx 14:46:04 09/11/03 forgot he also got larger Manley SS exhaust valves - boileralum 15:09:03 09/11/03 What is the difference between stock oil pump and toga? (n/m) - MikeH(Twin GT35BB Incon Z) 17:56:50 09/11/03 Re: Nissanzxman & I just picked up his motor from the machinist - SactoTodd 14:51:04 09/11/03 it had to be bored slightly for the larger pistons. His - boileralum 15:12:43 09/11/03 thanks. (n/m) - SactoTodd 16:19:26 09/11/03 Here ya go. - nissanzxman 07:20:29 09/12/03
Post a Followup	You cannot reply to this message because you are not logged in.