TwinTurbo.NET: Nissan 300ZX forum - Re: Damn bro, sorry missed the IM :(
People Seeking Info
 
   


     
Subject Re: Damn bro, sorry missed the IM :(
     
Posted by SR Productions on September 11, 2003 at 9:08 AM
  This message has been viewed 36 times.
     
In Reply To Damn bro, sorry missed the IM :( posted by ZBlacktt on September 11, 2003 at 12:27 AM
     
Message :Ok, looking by this, did the tires spin much off the line. That's a big 60ft for an Auto Z. What where you launching at? At anytime on the runs, did you see the Rpm's fly up fast, yet the car was not moving full force, as if the tranny was slipping?

The launch "felt" good. I power braked to2500RPM and left with slight wheel spin until 4000RPM and hooked. I shifted 1-2 and it went to 7200RPM. I didnt change my plugs yet but when I checked them they looked good. The run was on pump gas with no adjustments to the car. Just drove it in and ran it. Also, I dont think its a boost leak, I beleive its a vac leak(its hissing). I put in some fuel injector cleaner in the tank but when I ran it, it was down to 1/8 tank. The trans isnt slipping though.... Dillyyo,I will email you and maybe we can meet up....

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.