TwinTurbo.NET: Nissan 300ZX forum - do a SCed v8 engine swap into the 300ZX
People Seeking Info
 
   


     
Subject do a SCed v8 engine swap into the 300ZX
     
Posted by Z U N L on August 30, 2003 at 10:16 AM
  This message has been viewed 130 times.
     
In Reply To Perhaps an LS1? (n/m) posted by SuperCharged-Z- on August 30, 2003 at 06:06 AM
     
Message i was going to post this as a reply to one of your other messages, but this one seems more appropriate:

there have been a few v8 swaps that i have seen, and it would probably make more power and be more reliable of a power plant (than a vg30de(tt) that has been supercharged), and it's even possible that you could get it to fit better.

if you are dead set on a supercharger and a 300zx application, then that is really the way to go.

that said, in regards to an LT1 or LS1, i think that you would do better with an older domestic v8. i'm no expert on domestic powerplants, but i get a feeling that the ls1 or lt1 are going to be a little bit too large to fit in the Z engine bay. i don't really know about the fitment for sure, but i would suggest you do a lot of research on:
(a) the process of engine swapping in general
(b) specific dimensions and factors of the 300zx that you will have to deal with
(c) domestic powerplants that can take a sc and will fit with relatively (as relative as possible) little custom work.



"The two seater is being joined in a few weeks by a larger two-plus-two model with a rear seat for munchkins." ~Jim Mateja, Chicago Tribune, in regards to the Z32.

Andrew Janeshek // jnshk@aol.com // 1992 NA 2+2 [Stage 2-ish]
Click here for my home page.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.