Subject	I agree, but a lot of people think, that they will make
Posted by	George(boost-solutions.com) on August 20, 2003 at 4:56 PM
	This message has been viewed 100 times.
In Reply To	freezing the IC is ghey imho posted by aliaZ (IC Nazi) on August 20, 2003 at 04:30 PM
Message	750rwhp with TD05s and stock block. Try to tell them what is real world:-) George(www.boostsolutionsinc.net) >
Follow Ups	Bitter sweet day at the dyno today -------> - Kyle(Houston) 15:01:06 08/20/03 bummer sorta - nixit 15:11:03 08/20/03 Well...it is what we expected---> - Kyle(Houston) 15:21:18 08/20/03 oh my. looking forward to it! (n/m) - nixit 15:39:10 08/20/03 So which clutch are you going to use on it? - ZHOUND 16:20:50 08/20/03 It is up in the air right now----> - Kyle(Houston) 17:45:22 08/20/03 thicker head gasket or change pistons? (n/m) - wickdGSXR 16:47:27 08/20/03 Damn! Give me that motor, beefed up auto, and a 1/4 mile... (n/m) - Arnel(Z32racing.com) 15:12:23 08/20/03 Yea... What Arnel said. (n/m) - CatDaddy(OKC) 16:34:11 08/20/03 Have U made a pass this year? You're not on my '03 list yet. (n/m) - Arnel(Z32racing.com) 17:02:25 08/20/03 No.. Working too much. - CatDaddy(OKC) 21:21:34 08/20/03 why is the torque so low? It differs from the hp by over 100 (n/m) - robbase9 15:15:09 08/20/03 It is not "tuned" yet....see my response to Nixit..... (n/m) - Kyle(Houston) 15:21:58 08/20/03 It's basic physics >> - ChristopherTheOne 15:26:58 08/20/03 Basic physics or how stuff works lmao :) - gtclk 16:34:10 08/20/03 I wrote that freehand... >> - ChristopherTheOne 22:22:48 08/20/03 probably has more aggressive cams - Marshall 16:17:19 08/20/03 what's the date on that SCC mag?? - takirb 15:17:56 08/20/03 Feb 2002? - SactoTodd 15:52:45 08/20/03 "through the SCC Street car challenge a year and a half ago" - Borg79(ON) 16:27:09 08/20/03 help me with that math - SactoTodd 16:40:54 08/20/03 Any no NOS charts? - Chip(GMS Racing) 15:21:30 08/20/03 Not yet..but I can tell you that at 19Lbs of boost they ---> - Kyle(Houston) 15:25:16 08/20/03 Does tuning mean a 8200+ Redline now :) (n/m) - ZBlacktt 17:16:38 08/20/03 Nope....he is on an old motor----> - Kyle(Houston) 17:46:21 08/20/03 Same here. 1.5 bar isn't much for them. - TwinTurboPete 00:28:35 08/21/03 Sweet!! I can't wait till your next run! (n/m) - Spongerider :) 15:24:24 08/20/03 Great stuff! (n/m) - SeedyROM 15:29:57 08/20/03 That is some real power:-) Good job:-) I have to freeze my > - George(boost-solutions.com) 15:51:33 08/20/03 Kyle said they *didn't* freeze them on this car (n/m) - boileralum 16:02:49 08/20/03 100% correct....we probably could have gained 80-100 Rwhp--> - Kyle(Houston) 16:11:55 08/20/03 :-) I never said he did, but just mentioned it:-) (n/m) - George(boost-solutions.com) 16:42:02 08/20/03 freezing the IC is ghey imho - aliaZ (IC Nazi) 16:30:32 08/20/03 makes your balls bigger - genic 16:41:04 08/20/03 No shrinkage theory? :) (n/m) - Black Mammoth (VA) 16:42:52 08/20/03 Not FMICS, but freezing :-) (n/m) - George(boost-solutions.com) 16:51:43 08/20/03 I agree, but a lot of people think, that they will make - George(boost-solutions.com) 16:56:17 08/20/03 Poor Wagz....short lived record ;) (n/m) - Black Mammoth (VA) 16:13:59 08/20/03 haha...not exactly (n/m) - NR98 (next year) 16:31:42 08/20/03 Do you know the numbers? :) (n/m) - Black Mammoth (VA) 16:35:54 08/20/03 z cars exsist with much more than either of them - genic 16:40:17 08/20/03 Right...but I was thinking a record for US Z32s..am I wrong? (n/m) - Black Mammoth (VA) 16:42:07 08/20/03 honestly...no idea. probably close - genic 16:46:05 08/20/03 Some1 needs to maintain a new site: www.z32dynocharts.com :) (n/m) - Arnel(Z32racing.com) 16:52:48 08/20/03 300zxclub.com, has something like that under 'rides' - Janders 17:13:26 08/20/03 they never post ones that are submitted...that site sux (n/m) - Chris(NJ) 18:13:26 08/20/03 local here just picked up some GT30 Turbos =c) - CaptanZap 18:37:00 08/20/03 very true, I know of many over 800RWHP in Japan..but - BooZTT (Hawaii) 17:12:07 08/20/03 um how bout on a stock bottom???? (n/m) - Wagz 17:22:31 08/20/03 Some are priveledged other are not. :) (n/m) - Milo (San Antonio, TX.) 16:43:45 08/20/03 He said XXX. (I was hoping XXXX)... (n/m) - SooperZ95 17:18:33 08/20/03 no, i never said i was hoping for XXXX, my car is not - Wagz 17:30:52 08/20/03 No, I was hoping for XXXX, lol... -----> (n/m) - SooperZ95 21:03:26 08/20/03 ...and I can't wait til Friday. I'm sure the #s are amazing - SooperZ95 21:09:50 08/20/03 yes, my best #'s were quite a bit higher than 600 (n/m) - Wagz 21:43:13 08/20/03 hahaha....not with TD05 16g's....you were dreaming (n/m) - NR98 (next year) 17:39:45 08/20/03 yes he does (n/m) - Wagz 17:30:05 08/20/03 lol....don't tell them that...now I'll get a mailbox full of - NR98 (next year) 17:41:36 08/20/03 may be out tomorrow on the Sport Z site anyway! (n/m) - Wagz 17:46:16 08/20/03 "unfrozen" intercoolers, no NOS. - SactoTodd 16:43:33 08/20/03 oooouch (n/m) - genic 16:45:14 08/20/03 hmm...lets see - NR98 (next year) 17:09:35 08/20/03 Your #2 is the same method used on Outlaws 741rwhp run (n/m) - John@Z1 17:36:57 08/20/03 As John posted, "freezing the I/C" is just spraying it with - Chip(GMS Racing) 17:54:54 08/20/03 correct...this is what it looked like when we sprayed mine - Wagz 17:57:13 08/20/03 You cheater! - Chip(GMS Racing) 18:13:36 08/20/03 u know me!! :) - Wagz 18:41:43 08/20/03 Yep, see ya there. Hopefully my car will be there. (n/m) - Chip(GMS Racing) 10:40:57 08/21/03 TD06-20G's are pretty beefy turbos.. - AshsZ of Z1Motorsports.com 17:15:23 08/20/03 Yeah, the TD06s are good for over700rwhp, or actually close - George(boost-solutions.com) 17:18:45 08/20/03 Yeah they weren't even starting to flow right----> - Kyle(Houston) 18:46:05 08/20/03 my top dyno # was obtained w/ only a 60shot of NOS to - Wagz 17:28:19 08/20/03 i havent lost anything yet :) (n/m) - Wagz 17:19:39 08/20/03 and lets keep in mind im on stock pistons/rods & only - Wagz 17:21:17 08/20/03 What happened to your built motor???-----> - Kyle(Houston) 17:48:36 08/20/03 lol bad usage of words i guess....i meant brand new rebuilt - Wagz 17:49:46 08/20/03 Yeah his motor is going on 3 yrs old :-/......... (n/m) - Kyle(Houston) 17:54:29 08/20/03 well w/ that logic, mine is 1.5 yrs old at this point (n/m) - Wagz 18:11:34 08/20/03 thanks 4 the info btw, i corrected it (n/m) - Wagz 17:54:34 08/20/03 Are the Pistons Nissan??........... (n/m) - Kyle(Houston) 18:04:54 08/20/03 yes, i have nissan 0.020 over pistons that have been swain - Wagz 18:11:03 08/20/03 Coolio....thanks for clearing that up...... (n/m) - Kyle(Houston) 18:14:27 08/20/03 sorry bout that, i had put that info in like a year ago - Wagz 18:17:50 08/20/03 Kyle that is not a fully built engine. Read the specs. - John@Z1 18:01:39 08/20/03 wow...and he was even using SMIC's (n/m) - aliaZ (IC Nazi) 16:33:47 08/20/03 AND 3" pipes... ;) - LordZ 16:44:14 08/20/03 i was making a post about it; - nixit 16:46:55 08/20/03 hehe me too. but i like stiring the pot. (n/m) - LordZ 16:48:53 08/20/03 With TD06s YOU need 3" pipes. The outlet on the turbine is - George(boost-solutions.com) 16:57:48 08/20/03 LOL, I've already said my peace on this......lol (n/m) - ZBlacktt 17:20:25 08/20/03 Obviously not... ;) (n/m) - LordZ 18:01:00 08/20/03 So! ;) - ZBlacktt 18:09:14 08/20/03 Want a General post too :) - ZBlacktt 19:18:57 08/20/03 It has it's place...just not on near-stock/mild turbo - SeedyROM 19:24:22 08/20/03 stock? mild? does that sound like me? :) - LordZ 21:15:09 08/20/03 Since he was using NOS, it is OK:-) - George(boost-solutions.com) 16:47:54 08/20/03 Correct ;-)....... (n/m) - Kyle(Houston) 17:49:19 08/20/03 He doesn't live too far from me and that car is C-L-E-A-N! - P Rock(OH) 16:43:23 08/20/03 2nd...nice car....whole lotta money into that bad boy (n/m) - NR98 (next year) 17:13:22 08/20/03 Yea, but after that showing in SCC in 2002 looks - ZBlacktt 17:34:25 08/20/03 I have been through this before....He had 0 seat time ----> - Kyle(Houston) 17:51:46 08/20/03 LOL, yea that was me you where talking too back then :) - ZBlacktt 18:05:58 08/20/03 great #'s my friend, nice to see some big #'s hitting - Wagz 17:21:56 08/20/03 Did not Bryan make like 576rwhp on pump gas and 1.3 bar with - George(boost-solutions.com) 17:23:02 08/20/03 Very different turbos and headers. (n/m) - ZHOUND 17:36:15 08/20/03 and different cams, valves, head gaskets,...etc....etc..... (n/m) - Kyle(Houston) 17:53:05 08/20/03 574rwhp @ 1.25bar, A/F 11:1, no NOS or freezing IC - kuah@splparts.com 17:41:04 08/20/03 The hp and torque seems low at 19 lb of boost. (n/m) - MikeH(Twin GT35BB Incon Z) 19:40:08 08/20/03 Hmmmm---->>> - Kyle(Houston) 21:43:50 08/20/03 C12 is leaded fuel, correct? Was Wags done on unleaded? - NSANY(ATL) 08:07:59 08/21/03
Post a Followup	You cannot reply to this message because you are not logged in.