Subject	I definitely approve. What are your impressions
Posted by	aliaZ (IC Nazi) on August 14, 2003 at 10:30 AM
	This message has been viewed 25 times.
In Reply To	How do they compare to yours? Do you approve? (n/m) posted by Woody75 (Denver) on August 14, 2003 at 10:11 AM
Message	on the Swain coating? I still haven't sent my stuff off for coating...my engine is still a long way from being done
Follow Ups	Finally, my MS manifolds are here (Dial-up do not attempt) - Woody75 (Denver) 08:47:54 08/14/03 Sweetness Tim! Your patience has run out...time to drive! :) (n/m) - 5150Z 08:58:29 08/14/03 Drive? I just want to be able to back it out to wash it :) (n/m) - Woody75 (Denver) 09:01:46 08/14/03 Bout damn time... (n/m) - LordZ 09:50:18 08/14/03 In that last pic does that hole go all the way through? >> - SlicktopTT 09:57:48 08/14/03 You mean where the turbo mounting stud goes? (n/m) - Woody75 (Denver) 10:02:40 08/14/03 Yup I guess that's what it is. (n/m) - SlicktopTT 10:11:46 08/14/03 I think once its back in I will have to smooth it down. - Woody75 (Denver) 10:19:23 08/14/03 Ok, few questions... - BigTDogg 09:59:17 08/14/03 Mike Smith did the manifold work. - Woody75 (Denver) 10:07:03 08/14/03 Get to work...slacker!! (n/m) - BigRob 10:08:05 08/14/03 Thanks for the info. (n/m) - BigTDogg 10:09:01 08/14/03 looks good Tim (n/m) - aliaZ (IC Nazi) 10:08:18 08/14/03 How do they compare to yours? Do you approve? (n/m) - Woody75 (Denver) 10:11:47 08/14/03 I definitely approve. What are your impressions - aliaZ (IC Nazi) 10:30:45 08/14/03 Seems like pretty good stuff. - Woody75 (Denver) 10:44:47 08/14/03 Do you have one cleared tail and one not cleared? (n/m) - BigTDogg 16:28:29 08/14/03 Been covered before...I have 2 Z's. (n/m) - Woody75 (Denver) 16:57:02 08/14/03 I knew that, I just wasn't fast enough to figure out - BigTDogg 17:48:52 08/14/03 Very nice! (n/m) - Arthur 10:18:49 08/14/03 Very nice Tim!! Wish I was in CO for a ride when its done! (n/m) - therinL 10:30:07 08/14/03 very nice! (n/m) - Wagz 11:17:21 08/14/03 Awesome! VERY nice work my Mr Smith - Turbodog (CT) 13:06:32 08/14/03 Your torque numbers are off, they're slightly higher - BigTDogg 13:19:20 08/14/03 Now THAT is how it's done. (n/m) - SeedyROM 13:15:53 08/14/03 Three years without a running Z for me. Good luck! (n/m) - ProfeZZor X 13:59:23 08/14/03
Post a Followup	You cannot reply to this message because you are not logged in.