Subject	yes, to make decent flow, extensive porting and
Posted by	Janders on August 10, 2003 at 9:55 PM
	This message has been viewed 23 times.
In Reply To	Wouldn't that disrupt the smooothness of the interface posted by AshsZ of Z1Motorsports.com on August 10, 2003 at 09:48 PM
Message	port matching would have to be done with the plat in place, unless it was a very thin plate <1cm
Follow Ups	Any1 Interested in a NOS plate? - Carlos Ramirez 21:19:41 08/10/03 What about the coil packs reaching the plugs? Grind mounts? (n/m) - Snoguitar 21:23:44 08/10/03 ah very important point :-) - Carlos Ramirez 21:34:47 08/10/03 Depends on cost but yes. (n/m) - John(Houston) 21:33:49 08/10/03 Wouldn't that disrupt the smooothness of the interface - AshsZ of Z1Motorsports.com 21:48:42 08/10/03 yes, to make decent flow, extensive porting and - Janders 21:55:45 08/10/03 Wouldn't it be easier to tap the upper intake manifold? (n/m) - MikeH(Twin GT35BB Incon Z) 23:41:13 08/10/03
Post a Followup	You cannot reply to this message because you are not logged in.