Subject	Any1 Interested in a NOS plate?
Posted by	Carlos Ramirez on August 10, 2003 at 9:19 PM
	This message has been viewed 86 times.
Message	I been thinking of getting one made. The plate would go between the top and lower plenum. The NOS and fuel fittings would be setup so they are not in the way. There is a few issues I see like the EGT tubes and the intake plenum would be higher so it may cause some issue for strut tower braces. However the advantage would be that the install would be clean and be direct port which would provide a better distribution of NOS and Fuel and ofcourse if you would want to run a 300 shot the system it would support it. The minimal support shot is 80hp with a direct port so that would be the only real down side. The other idea I had was to make the plates go between the intake plenum and throttle bodies but I don't think we would get a good distribution that way.
Follow Ups	Any1 Interested in a NOS plate? - Carlos Ramirez 21:19:41 08/10/03 What about the coil packs reaching the plugs? Grind mounts? (n/m) - Snoguitar 21:23:44 08/10/03 ah very important point :-) - Carlos Ramirez 21:34:47 08/10/03 Depends on cost but yes. (n/m) - John(Houston) 21:33:49 08/10/03 Wouldn't that disrupt the smooothness of the interface - AshsZ of Z1Motorsports.com 21:48:42 08/10/03 yes, to make decent flow, extensive porting and - Janders 21:55:45 08/10/03 Wouldn't it be easier to tap the upper intake manifold? (n/m) - MikeH(Twin GT35BB Incon Z) 23:41:13 08/10/03
Post a Followup	You cannot reply to this message because you are not logged in.