Subject	I wouldn't pay a lot to have it done unless it's Extrude Hon
Posted by	Milo (San Antonio, TX.) on August 07, 2003 at 3:08 PM
	This message has been viewed 67 times.
In Reply To	Ported stock manifolds with stock turbos: Worth it? posted by nissanzxman on August 07, 2003 at 02:36 PM
Message	ing. I forgot who did a bench test on it, but the gains were minimal. Get a drill and a alum oxide bit and got to town, it's probably the same thing the guy who is doing it is going to do. Do it yourself and save the money. On the otherhand the Extrude Honing process is highly recommened (IMO). But it is expensive.
Follow Ups	Ported stock manifolds with stock turbos: Worth it? - nissanzxman 14:36:28 08/07/03 I would say no but how much is it costing you? (n/m) - Rob'Z 14:52:32 08/07/03 Sorry bout that... - nissanzxman 14:56:20 08/07/03 I wouldn't pay a lot to have it done unless it's Extrude Hon - Milo (San Antonio, TX.) 15:08:50 08/07/03 You must work for extrude hone (n/m) - MikeH(Twin GT35BB Incon Z) 15:14:12 08/07/03 I wish.... free extrude honing. :) (n/m) - Milo (San Antonio, TX.) 17:27:54 08/07/03 gains are minimal even for extrude honing - boileralum 15:33:25 08/07/03 That who did it! But yeah the gains were minimal, but - Milo (San Antonio, TX.) 17:27:04 08/07/03 Extrude Whore is not worth the money (n/m) - MikeH(Twin GT35BB Incon Z) 18:13:51 08/07/03 you'd be wasting your money - CaptanZap 15:27:19 08/07/03
Post a Followup	You cannot reply to this message because you are not logged in.