lookin good (n/m) posted by JustinChien on August 02, 2003 at 04:14 PM
Message
there web page and the tank prices aren't bad but looking at the build work on the ends it looks like they dont have a pipe bender to form some smooth angles. Say similar to the side mounts that would require a bend in the neck on the outside of the tanks. I also looked at the one Z1 is selling on ebay and it appears also that the endtanks are all made at right angles with just a straight pipe exiting. then your left to figure out the rest such as making the turns to connect to the i/c ducting. I wonder if anyone has a set of side mounts made and how they manufactured the end tanks with the piping that id similar to factory so all you would need to do is use a normal amount of duct connector similar to stock.
