| Message |
I just hope you do much better than me on the dyno :) I will also be going back in a few weeks with Kevin. He built my car. He says 750whp wont be hard with my setup. :Since some people started thinking that we have dropped all the work on our project car, here is a little update. The car is perfectly tuned for low boost. We installed the stiffer HKS wastegate springs yesterday, so out low setting will be 18 psi vs 10 psi.
:The car awaits:
:- 2 dump pipes from the wastegates down ( they are open now, not good to shoot flames around:-)
:- one intake pipe from the pass side filter to the turbo ( the car runs fine like this except tha the passenger side turbo sucks hot air)
:The Z idles nicely at 800rpms, it is a bit lopey with the cams, but it is fine. We revved it already to 7500rpms, an it runs beautifully. But that was at the 10 psi setting.
:Our goal is to dyno tune and obtain a highboost dyno chart next Fri.
:We will keep everybody updated:-)
:Here are some movies of the beast running, and some pictures:-)
: Movie1
: Movie2
:And here are some fresh snapshots:-) Sorry, the car is dirty a bit...
:
:
:
:
:
:
|
 |
