TwinTurbo.NET: Nissan 300ZX forum - you must be kidding me >>
People Seeking Info
 
   


     
Subject you must be kidding me >>
     
Posted by genic (konig whore) on December 14, 2000 at 3:47 PM
  This message has been viewed 9 times.
     
In Reply To I beat a lot of cars in my last Z>>>> posted by NVMYZTT on December 14, 2000 at 03:35 PM
     
Message almost stage III ..stock exhaust ..gutted cats, but i assume you were what..13.5 psi?

vr4 musta been from a roll, c5 (not unless you where more psi than stock) ..same with the ls1's and ram-air. but if you where "almost" stage III then uhhh...i assume you have jets. so if you had jets, that would make you a bit more than "almost stage III" that would make you like IV (with the gutted cats and what not)..and then i can believe it...other than that...not beliving it..
cause i am 1 1/2 and if i had gutted all four cats, i still wouldnt be able to beat them that you listed. (and ask doan about my car...i got the jump on him, and he couldnt reel me in ..and i race my cousin's c5 all the time, and he pulls 1 length on me all the time...no matter what we run to...its always 1 length)

--------------------------------------------------------------------------------
and now, we take a moment to reflect on the stupidity that roams the land...

quote:
--------------------------------------------------------------------------------
Originally posted by infinite loop:
Shit talking is a lot like a chess game. However, what exactly is the point of playing against someone who yells out 'KING ME!' when getting his pawn to the opposite side of the board?

--------------------------------------------------------------------------------
Originally posted by newbie:
'KING ME' is the term used in Checkers.
--------------------------------------------------------------------------------

It's good to see someone paying attention...

--------------------------------------------------------------------------------
Twin Turbo Zs of Dallas

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.