TwinTurbo.NET: Nissan 300ZX forum - Re: Re: Excellent mail order @ Z1Motorsports.com
People Seeking Info
 
   


     
Subject Re: Re: Excellent mail order @ Z1Motorsports.com
     
Posted by EZEZ on July 09, 2003 at 11:39 AM
  This message has been viewed 49 times.
     
In Reply To Re: Excellent mail order @ Z1Motorsports.com posted by Tsefreeflow on July 09, 2003 at 10:44 AM
     
Message 1. I was quoted 300 Euro (~330 USD) in Ireland (by Nissan) for a replacement driveshaft centre bearing. The replacement one-piece was less costly than this by far.

2. The u-joints in the Z1Motorsports one-piece driveshaft are serviceable where the u-joints in the stock driveshaft are not (you need to buy the complete assembly from Nissan). I just figured if my CB was shot, then how far behind were my u-joints.

3. The Z1Motorsports one-piece driveshaft is one half of the weight of the stock two-piece... less rotational mass… a couple of lbs shaved off… etc…

I am sure that there are some who maintain the stock driveshaft is smoother at certain shaft rotational speeds etc.... perhaps this is a small price to pay for serviceability…

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.