Subject	Put it in a bench vice.
Posted by	Xi0nX4 (ohio) on July 06, 2003 at 12:55 PM
	This message has been viewed 24 times.
In Reply To	exactly how high-quality are those Titanium keys of ours? posted by ZEngineer on July 06, 2003 at 04:29 AM
Message	I have a heavey duty one in my garage that I use to reshape metal all the time. I make L brackets out of metal twice as thick as the z key with it and a hammer (not ti. though.). If the bend is in the wrong place i can just put it in and tighten it dodwn and it comes out straight again. So I imagine you could straighten a key too. Just try it a little bit at a time, and maybe wrap it in cloth to keep from scractching.
Follow Ups	exactly how high-quality are those Titanium keys of ours? - ZEngineer 04:29:14 07/06/03 Mine broke :( - X-STAT1C (Houston) 04:46:25 07/06/03 Strange, my 91 orig. is still in close to perfect condition (n/m) - therinL 09:35:20 07/06/03 mine too ... well, it cracked - markpearl91tt 15:07:30 07/06/03 I would try heating it up before straightening it. (n/m) - Escort Z 04:50:05 07/06/03 lol, I was just looking at Temp. Vs Ductility graphs for Ti - ZEngineer 05:00:38 07/06/03 Are you and Xstatic talking about OEM Ti key or replication? - Technomancer 07:04:44 07/06/03 dont know about Xstatic, but my key was the original one (n/m) - ZEngineer 07:15:57 07/06/03 mine is slightly bent (n/m) - AcdPa 08:15:38 07/06/03 They are stong but brittle. (n/m) - YugoBernie (NoVA) 08:49:32 07/06/03 I bent mine about the same amount and just bent it back with - Bernie 11:04:17 07/06/03 I would recommend that everyone with titanium keys make - DVDburn(MD) 12:21:57 07/06/03 Put it in a bench vice. - Xi0nX4 (ohio) 12:55:20 07/06/03 put it in a vice (n/m) - Spee 13:42:16 07/06/03 make sure its a smooth one and not one with the - Zmas 16:41:44 07/06/03 LOL, dat's what corkscrews are for! (n/m) - LoveBone 18:21:33 07/06/03
Post a Followup	You cannot reply to this message because you are not logged in.