Subject	Wow, and I thought the EVC IV was a pain :(
Posted by	ZBlacktt on July 05, 2003 at 3:02 PM
	This message has been viewed 76 times.
In Reply To	HKS EVC question posted by cant_z_me(OH) on July 05, 2003 at 11:48 AM
Message	We have our stepping motor in the exact same location. Where with your new model, it seems more of a pain this one. For the life of me I still just can't dial up and seem to know what I'm doing with this. I go to set it up for more boost and it starts flashing at me, then it shows the boost level before. Move the dial and it shows low setting, then high setting. Where I just want move the dial and get it to the setting I want and that's it. But it's not that easy for some reason. So I mess with it before the track or dyno and somehow get it set and leave it or I'll really mess it up. Is setting that one or programing it easy? The HKS EZ would be nice to just dial and go, but other than set to high and find out on the run, how safe is that? STAGE V++++ Going to XV+ and beyond :) Yellow Z STAGE II Going to XI+
Follow Ups	HKS EVC question - cant_z_me(OH) 11:48:56 07/05/03 dialup just say no (n/m) - cant_z_me(OH) 11:49:16 07/05/03 Both the vacuum hoses are open? - George(boost-solutions.com) 12:04:45 07/05/03 haha...that pic was from during the install - cant_z_me(OH) 12:41:22 07/05/03 i had my blitz unit in the same place. i didnt get too hot - genic 12:29:49 07/05/03 yea...it can't be the heat - cant_z_me(OH) 12:42:59 07/05/03 Wow, and I thought the EVC IV was a pain :( - ZBlacktt 15:02:32 07/05/03 Very very easy!!!!! (n/m) - Red300ztt96 16:36:26 07/05/03 its very easy, not a pain at all to work with------> - cant_z_me(OH) 21:58:34 07/05/03
Post a Followup	You cannot reply to this message because you are not logged in.