Subject	so if nothings hooked up there it wont hurt anything. sweet. (n/m)
Posted by	joel(PA) on June 29, 2003 at 1:40 PM
	This message has been viewed 25 times.
In Reply To	Those are water lines. You can by pass those. (n/m) posted by MikeH(Twin GT35BB Incon Z) on June 29, 2003 at 01:39 PM
Message
Follow Ups	pics of motor 3/4 built from yesterdays post - joel(PA) 12:57:24 06/29/03 link to yesterdays post - joel(PA) 12:58:34 06/29/03 You forgot pics of your manifold :) (n/m) - TwinTurboPete 12:59:56 06/29/03 hhaha, suree.................. - joel(PA) 13:00:47 06/29/03 shouldn't you be getting strapped on a dyno now? =) (n/m) - ZEngineer 13:07:55 06/29/03 Thats what I was thinking:) (n/m) - CarbonZTT 13:09:16 06/29/03 whats the latest on your car? (n/m) - joel(PA) 13:13:21 06/29/03 The pistons are taking forever to get to shawn - CarbonZTT 14:05:43 06/29/03 Hhhm part of the crankcase vent system, but don't see it - ZBlacktt 13:07:09 06/29/03 yeah, the service manual doesnt seem to show it either - joel(PA) 13:11:24 06/29/03 Or - ZBlacktt 13:12:23 06/29/03 Those are water lines. You can by pass those. (n/m) - MikeH(Twin GT35BB Incon Z) 13:39:20 06/29/03 so if nothings hooked up there it wont hurt anything. sweet. (n/m) - joel(PA) 13:40:46 06/29/03 hows the GB on pistons going, if only it was about 3 weeks - joel(PA) 13:41:56 06/29/03 polydyn is handlig it. (n/m) - MikeH(Twin GT35BB Incon Z) 13:55:47 06/29/03 can i say it ? (n/m) - Chris(NJ) 13:55:14 06/29/03 The only purpose those serve is as a coupling between - MikeH(Twin GT35BB Incon Z) 14:03:29 06/29/03 Well... - Z PYRATE 14:18:36 06/29/03 See above :) (n/m) - SeedyROM 17:12:48 06/29/03 They are there so you don't crack a plenum in cold weather - SeedyROM 15:39:04 06/29/03 Looking good..Can't wait to see it completed for the meet on - Pats300zx 15:34:38 06/29/03 Those lines are the TB water lines, bypass them - Zluster(Swapping engines) 16:42:54 06/29/03 Nice, But I think you should practice on the Putting Silicon - Antonio300zxTT 22:22:59 06/29/03
Post a Followup	You cannot reply to this message because you are not logged in.