Subject	pics of motor 3/4 built from yesterdays post
Posted by	joel(PA) on June 29, 2003 at 12:57 PM
	This message has been viewed 629 times.
Message	what runs in and out of these fittings???? i cant figure it out or find a diagram of the underneath of the plenum in the service manual. what runs to the one side, and where does it run to when it comes out? oh, and don't worry, that supposedly *red* "pink" oil cap is gonna go. i need a dipstick. anyone have one laying around they can sell me? i seem to have lost mine. also, anyone need any 2.5" straight Hose Techniques silicone? i bought two feet, and should only need about 1 foot. i will sell 12" to you for 70 bucks shipped. TRUST NO ONE. DEPEND ON NO ONE. SOMEONE PEOPLE CAN AND ALWAYS WILL BE INCONSIDERATE.
Follow Ups	pics of motor 3/4 built from yesterdays post - joel(PA) 12:57:24 06/29/03 link to yesterdays post - joel(PA) 12:58:34 06/29/03 You forgot pics of your manifold :) (n/m) - TwinTurboPete 12:59:56 06/29/03 hhaha, suree.................. - joel(PA) 13:00:47 06/29/03 shouldn't you be getting strapped on a dyno now? =) (n/m) - ZEngineer 13:07:55 06/29/03 Thats what I was thinking:) (n/m) - CarbonZTT 13:09:16 06/29/03 whats the latest on your car? (n/m) - joel(PA) 13:13:21 06/29/03 The pistons are taking forever to get to shawn - CarbonZTT 14:05:43 06/29/03 Hhhm part of the crankcase vent system, but don't see it - ZBlacktt 13:07:09 06/29/03 yeah, the service manual doesnt seem to show it either - joel(PA) 13:11:24 06/29/03 Or - ZBlacktt 13:12:23 06/29/03 Those are water lines. You can by pass those. (n/m) - MikeH(Twin GT35BB Incon Z) 13:39:20 06/29/03 so if nothings hooked up there it wont hurt anything. sweet. (n/m) - joel(PA) 13:40:46 06/29/03 hows the GB on pistons going, if only it was about 3 weeks - joel(PA) 13:41:56 06/29/03 polydyn is handlig it. (n/m) - MikeH(Twin GT35BB Incon Z) 13:55:47 06/29/03 can i say it ? (n/m) - Chris(NJ) 13:55:14 06/29/03 The only purpose those serve is as a coupling between - MikeH(Twin GT35BB Incon Z) 14:03:29 06/29/03 Well... - Z PYRATE 14:18:36 06/29/03 See above :) (n/m) - SeedyROM 17:12:48 06/29/03 They are there so you don't crack a plenum in cold weather - SeedyROM 15:39:04 06/29/03 Looking good..Can't wait to see it completed for the meet on - Pats300zx 15:34:38 06/29/03 Those lines are the TB water lines, bypass them - Zluster(Swapping engines) 16:42:54 06/29/03 Nice, But I think you should practice on the Putting Silicon - Antonio300zxTT 22:22:59 06/29/03
Post a Followup	You cannot reply to this message because you are not logged in.