Subject	Going to the dyno next week.
Posted by	TwinTurboPete on June 27, 2003 at 12:51 PM
	This message has been viewed 219 times.
Message	I will run 20psi on 94 octane and see what that gives me and then put in some C16 and try to run 30psi. I will gradually increase boost from 20psi to see if the car starts leaning out at higher boost levels. Hoping to get close to 600whp at 20psi on pump gas. I won't go leaner than 11:1 on pump gas. Will try to push the car to 11:5 on race gas. Timing will be set at 17. Should I play with my cam sprockets or leave them alone? I have my EGT's mounted right after the turbos where the 02 sensors are. I was scared to mount them on the manifold just in case a probe would break and destroy my turbos. What number shouldn't my Greddy EGT's pass to be on the safe side. 8? Thanks! Any hp predictions?
Follow Ups	Going to the dyno next week. - TwinTurboPete 12:51:52 06/27/03 i cant wait to see the results... - Roo 12:55:05 06/27/03 NOS lines have been passed but its not installed - TwinTurboPete 13:05:42 06/27/03 Good luck, put down some big numbers! (n/m) - Chip(GMS Racing) 13:22:41 06/27/03 Good luck. - ZHOUND 13:24:14 06/27/03 Going to run both octanes same day? (n/m) - ZBlacktt 13:27:14 06/27/03 i have my greddy EGT's mounted int he same spot as you do - trik300zx 13:40:36 06/27/03 Re: Going to the dyno next week. - sparkie 13:48:06 06/27/03 at 20 psi as is, it goes up to 790. - TwinTurboPete 14:08:00 06/27/03 Good luck!! (n/m) - SeedyROM 13:56:01 06/27/03 May the FORCE be with you:) (n/m) - LRD VDR 14:13:03 06/27/03 Can't wait to see those numbers!! Get on tape everything! ;) (n/m) - TheTwinZ (Peru) 14:44:34 06/27/03 Good luck, Pete! If my pass side intake pipe is ready>>> - George(boost-solutions.com) 15:58:39 06/27/03 You got my number a while ago.... - Oppaman Z 23:30:49 06/27/03 what a coincidence, I'm running 30psi too - ZEngineer 05:13:24 06/28/03
Post a Followup	You cannot reply to this message because you are not logged in.