Subject	install new circuit wiring with fuse adaptor
Posted by	RROBE99999 on June 19, 2003 at 1:59 PM
	This message has been viewed 48 times.
In Reply To	thats what i was thinking... posted by Roo on June 19, 2003 at 11:22 AM
Message	This is how I got power for my amp. I think I got it at Radio Shack or an Auto store. Its the easiest way to hook up new wires right into the fuse box. You pull out a fuse, and hook up your wire (hot) into this adaptor that goes at a right angle over the top of other fuses. You then plug the fuse into the adaptor to protect the old and new circuits. Its very low profile, so you can still put the cover on the fuse box. Hook up the ground wire to the chassis. There are some good spots near the fuse box.
Follow Ups	Wiring 4 Guages... - Roo 11:00:54 06/19/03 Ive always wired guages into: - therinL 11:06:04 06/19/03 But where exactly do you tap in? - Roo 11:11:52 06/19/03 pull the fuse, run the wire into the the slots where the - Scotts94z32 11:17:33 06/19/03 thats what i was thinking... - Roo 11:22:25 06/19/03 Could choose 2, 3 fuses to use based on each guage (n/m) - therinL 11:29:43 06/19/03 solder them all together into a single wire... - spyhunter 12:14:38 06/19/03 install new circuit wiring with fuse adaptor - RROBE99999 13:59:16 06/19/03
Post a Followup	You cannot reply to this message because you are not logged in.