Subject	Yes, I am afraid that when I enlarge it to 60mm, it will not
Posted by	George(boost-solutions.com) on June 16, 2003 at 7:33 PM
	This message has been viewed 34 times.
In Reply To	You would be taking quite a bit off drilling it to posted by JMT-Z(St. Louis) on June 16, 2003 at 07:28 PM
Message	be deep enough and the gauges might stick out. I had Lotek triple 52mm pod, and that one did not work out for 60mm. George(www.boostsolutionsinc.net) >
Follow Ups	Anybody knows if the Autometer triple gauge pillar can>>> - George(boost-solutions.com) 19:22:03 06/16/03 Re: Anybody knows if the Autometer triple gauge pillar can>>> - Slobo7x 19:25:37 06/16/03 You would be taking quite a bit off drilling it to - JMT-Z(St. Louis) 19:28:37 06/16/03 8mm to be exact. - Bobby12many 19:33:02 06/16/03 Yes, I am afraid that when I enlarge it to 60mm, it will not - George(boost-solutions.com) 19:33:43 06/16/03 I measured my 52 single gauge pod, and I came to the - boileralum 20:14:16 06/16/03 What gauges are you using? I crammed my A'pexi 60mm>> - Mike (Austin) 09:57:40 06/17/03 no but there are 60mm pillars that are custom made and - Carlos Ramirez 19:32:42 06/16/03 Ginn motorsports had some..... (n/m) - AndrewZ 19:34:28 06/16/03 Cybercraft. When did you go to the shop this morning? I came - George(boost-solutions.com) 19:34:58 06/16/03 And they are out of business... (n/m) - George(boost-solutions.com) 19:35:31 06/16/03 It was a long weekend. Can you please bring again? - Carlos Ramirez 20:02:52 06/16/03 I cannot really drive it when it is raining. One of my turbo - George(boost-solutions.com) 21:03:42 06/16/03 sounds good to me.. and yes don't drive it in the rain - Carlos Ramirez 21:24:31 06/16/03 I'll sell you my Stealin' center dash gauge pod :) (n/m) - Kez43 20:17:36 06/16/03 How much? (n/m) - boileralum 20:20:32 06/16/03 Make me an offer - Kez43 21:32:18 06/16/03 Nope, I tried that route when Cybercraft could not deliver - Chip(GinnMotorsports) 09:26:31 06/17/03
Post a Followup	You cannot reply to this message because you are not logged in.