Subject	The reason Carlos has higher HP
Posted by	PEwithaZ on December 07, 2000 at 10:29 PM
	This message has been viewed 8 times.
In Reply To	Re: Ok here is my dyno results from today.. posted by got rice? on December 07, 2000 at 09:50 PM
Message	Is because his torque does not decay as much at high rpm. HP is calculated from torque by the equation HP = torque*rpm/5252. The key to maximum peak HP is to keep the torque up. The story behind the NOELF's symbol RECYCLE PAPER - KEEP A TREE FROM BEING PLANTED Click Here to Go to My Performance Car Web Page
Follow Ups	Ok here is my dyno results from today.. - Carlos Ramirez 21:44:25 12/07/00 Re: Ok here is my dyno results from today.. - got rice? 21:50:58 12/07/00 Well I have test pipes and AIVs are just open - Carlos Ramirez 22:01:25 12/07/00 AIVs are inoperative during open loop (n/m) - got rice? 22:05:41 12/07/00 also I haven't clean my air intake in a long time.. - Carlos Ramirez 22:03:16 12/07/00 it won't make *that* much of a difference (n/m) - got rice? 22:06:19 12/07/00 The reason Carlos has higher HP - PEwithaZ 22:29:07 12/07/00 tq curves look the same on both dyno printouts (n/m) - got rice? 05:58:30 12/08/00 Can't be - HP is calculated from torque - PEwithaZ 22:25:46 12/08/00 Would the higher torque # than HP mean it's running rich? (n/m) - ZBlacktt 21:53:07 12/07/00 no, majority of stage 3 or higher TTZs put out more - got rice? 21:58:14 12/07/00 See my comment above - PEwithaZ 22:30:41 12/07/00 Wll sort of...all Stage III or above do that >>> - wesman [92TT-less in big D] 22:32:31 12/07/00 Get AFC and TUNE that sucker! (n/m) - Chip(Southern.MS) 22:07:47 12/07/00 good numbers! gap the plugs down a little.... - NVMYZTT [ BUSH-CHENEY 2000 ] 00:38:03 12/08/00 Plugs are at .35 already :-) (n/m) - Carlos Ramirez 07:02:29 12/08/00 What is your timing set @? - HAYATO 09:13:02 12/08/00 Should have been at 17 degrees.. But I am not sure any more. (n/m) - Carlos Ramirez 15:06:12 12/08/00
Post a Followup	You cannot reply to this message because you are not logged in.