Subject	You think the area on top of the plenum will reach 460F!!
Posted by	PLEAZURE in CA (SD) on June 12, 2003 at 1:26 AM
	This message has been viewed 17 times.
In Reply To	Most solders melt at 460F, no good for engine (n/m) posted by NytWolf on June 11, 2003 at 07:13 PM
Message	no way ! Matt 91TT Aztec Red stg III+
Follow Ups	Did you use butt connectors or soldering for new injector - PLEAZURE in CA (SD) 18:39:38 06/11/03 soldering is recommended (n/m) - BryZ32TT 18:45:24 06/11/03 Use high-temp solder (n/m) - NytWolf 18:49:25 06/11/03 there's a LOW-temp solder??? (n/m) - Halo Z 19:06:49 06/11/03 Most solders melt at 460F, no good for engine (n/m) - NytWolf 19:13:25 06/11/03 i guess the stuff at work is the good stuff. (n/m) - Halo Z 19:36:41 06/11/03 You think the area on top of the plenum will reach 460F!! - PLEAZURE in CA (SD) 01:26:21 06/12/03 Always solder and heat shrink..... - zxtaz 19:08:17 06/11/03 I used whats called an environmental splice, basically - DAYTONAZ 19:16:26 06/11/03 where are you getting yours? - fourZero 19:18:48 06/11/03 Solder it is ...unless you can find a vendor for that high - PLEAZURE in CA (SD) 01:25:19 06/12/03
Post a Followup	You cannot reply to this message because you are not logged in.