Subject	Use high-temp solder (n/m)
Posted by	NytWolf on June 11, 2003 at 6:49 PM
	This message has been viewed 15 times.
In Reply To	Did you use butt connectors or soldering for new injector posted by PLEAZURE in CA (SD) on June 11, 2003 at 06:39 PM
Message
Follow Ups	Did you use butt connectors or soldering for new injector - PLEAZURE in CA (SD) 18:39:38 06/11/03 soldering is recommended (n/m) - BryZ32TT 18:45:24 06/11/03 Use high-temp solder (n/m) - NytWolf 18:49:25 06/11/03 there's a LOW-temp solder??? (n/m) - Halo Z 19:06:49 06/11/03 Most solders melt at 460F, no good for engine (n/m) - NytWolf 19:13:25 06/11/03 i guess the stuff at work is the good stuff. (n/m) - Halo Z 19:36:41 06/11/03 You think the area on top of the plenum will reach 460F!! - PLEAZURE in CA (SD) 01:26:21 06/12/03 Always solder and heat shrink..... - zxtaz 19:08:17 06/11/03 I used whats called an environmental splice, basically - DAYTONAZ 19:16:26 06/11/03 where are you getting yours? - fourZero 19:18:48 06/11/03 Solder it is ...unless you can find a vendor for that high - PLEAZURE in CA (SD) 01:25:19 06/12/03
Post a Followup	You cannot reply to this message because you are not logged in.