Subject	Where on the sub is the hole? Cone or surround????
Posted by	Bobby12many on June 10, 2003 at 6:41 PM
	This message has been viewed 26 times.
In Reply To	SZR: Hey guys... I did the stupidest thing possible while posted by Japocalipse on June 10, 2003 at 05:18 PM
Message	Unless it pierced through the spider (the flat accordian thing the cone is attached to) it is quite easy to fix. Go buy some Silicone RTV sealant and seal the hole up as best you can. You might even want to cut out a little piece of plastic from a thick shopping bag or something and use it to patch the hole just to make sure your fix is air tight. Contrary to a few miseducated members here, a hole in your sub DOES matter. It will affect the sound and response of your sub on all frequencies... If you ended up doing ban-damage, just search for Kove Audio on google, and look f0r some online distributors. The armageddons are nice drivers. The "witcho" incident: "fuck you bitch you fuckin started this shit . say sorry or bring down your slow as z witcho slow as pops in the car and i'll teach you both a new lesson. Not internet related but PAIN related" ....posted by z32pilot on April 09, 2003 at 11:30 PM My sounddomain page Leave some feedback on my site!
Follow Ups	SZR: Hey guys... I did the stupidest thing possible while - Japocalipse 17:18:06 06/10/03 whatever you use will probably distort the sound some - kandy2dr 17:23:34 06/10/03 new sub time...no way to fix it. (n/m) - Spee 17:23:38 06/10/03 if its the surround you can replace it. - TARGETZ 17:45:05 06/10/03 Hole doesn't matter. - JustinChien 18:08:54 06/10/03 bet that will hold up GREAT under high SPL (n/m) - fourZero 18:51:24 06/10/03 Use some CrayGlue if it's on the foam surround >> - my91z 18:11:39 06/10/03 Where on the sub is the hole? Cone or surround???? - Bobby12many 18:41:56 06/10/03 Its just the rubber surround... I was planning on doing the - Japocalipse 22:22:45 06/10/03 you can fix it with black SILICONE!!! i did that once, - Pure-Evil 19:08:27 06/10/03
Post a Followup	You cannot reply to this message because you are not logged in.