Subject	well, installed all 6 injectors,went smooth.I dont know
Posted by	BarryGZX on June 07, 2003 at 4:36 AM
	This message has been viewed 137 times.
Message	how you guys would break those inj. cap bolts by doing the dremel method...thats crazy,i had to use vise grips to get them b-otches loose!I replaced those phillips for 6 pointers.Anyway I took the Z for a rip after the install yesterday and it still ran like shit,...I was like....WHAT THE F@!$..!!!!!I mean code 55,triple checked all connections,tested all sensors,wiring,no vac. leaks,ETC.,compression is between 186 to 170 for all six which is tits for 190,000!!...Until about 3 hours ago coming back from dinner...its starts running better!!Must of still been some shit left over from that bad gas.I'm guessing the o2's prolly got jacked up to ...which will be replaced tomorrow.
Follow Ups	well, installed all 6 injectors,went smooth.I dont know - BarryGZX 04:36:57 06/07/03 mine ran like crap for a little bit right after install, too (n/m) - sebring1970 (robo) 05:02:52 06/07/03 your from harrisburg,ever been to wilkesbarre? (n/m) - BarryGZX 05:05:18 06/07/03 theres a resort called the woodlands..great nite life, - BarryGZX 05:15:47 06/07/03 I'll have to check it out. Just drove by Wilkesbarre, never - sebring1970 (robo) 05:23:24 06/07/03 from NJ and lived in milford PA for about 6 yrs before - BarryGZX 11:38:42 06/07/03 grease your o rings? (n/m) - Halo Z 07:03:37 06/07/03 good point - sebring1970 (robo) 09:33:02 06/07/03 absolutly!!! (n/m) - BarryGZX 11:40:38 06/07/03 I bet you never knew your Z can pull like that - PLEAZURE in CA (SD) 01:14:37 06/08/03
Post a Followup	You cannot reply to this message because you are not logged in.